This lesson will teach the basic physical and operational characteristics of passenger vehicles and buses, including: overall height, length, width, ground clearances, rear overhang; Gross Vehicle Weight and GVWR, axle weights; wheels and rims, tires, tire ratings; mirrors, steer wheels, lighting, windshield, windshield wipers; engine compartments, basic electrical system; brake systems and spare tire storage. You will also learn techniques for proper driver seat and mirror adjustments.
By knowing the major components and items on the bus, you can: have a better understanding of how to diagnose problems; gain additional knowledge of your vehicle’s capabilities and limitations; and accurately describe faulty equipment to your mechanics.
Buses come in all kinds of weights, designs, and sizes. There are four different types of buses:
Type A — The smallest bus. Some carry up to 30 passengers with a GVWR of less than 10,000 lbs., while others have a GVWR of 10,000 lbs. or more.
Type B — Some are designed to carry 16 passengers or less (including the operator) with a GVWR of 10,000 lbs. or less; others have a GVWR of more than 10,000 lbs.
Type C — A traditional or conventional bus.
Type D — Designed for carrying more than 70 passengers. Most are 33 to 45 feet in length, 9 to 11 feet in height, and weigh about 12,000 lbs. When fully loaded, the weight can be around 20,000 lbs.
The wheelbase determines the bus’s turning radius and tail swing. Type A and B: wheels shall be disc-type with hubs of not less than five studs; dual rear wheels required for all buses over 10,500 lbs. GVWR. Type C and D: wheels shall be disc-type and may be hub or stud-piloted. Type D rear tandem suspension shall have a minimum of six tires.
All tires on any given axle shall be of the same size, ply, and load rating. Recapped or retread tires are not permitted on front axles. Re-grooved tires are not permitted. Section repairs are not permitted in front tires. Spare tire, if carried, shall be mounted in an accessible location outside the passenger compartment.
All mirrors shall be easily adjustable but rigidly braced to reduce vibration. Interior glass mirrors shall be either laminated or tempered with rounded corners and protected edges. Mirrors shall be 6 x 16 inches minimum for Type A buses and 6 x 30 inches minimum for Types C and D buses. Rearview mirrors shall provide clear views of the left and right sides and to the rear for at least 200 feet. All rearview mirror systems shall be heated and power remote-controlled.
Cross-View Mirror System: Shall be heated and provide indirect vision from ground level below the front bumper, around the left and right front corners, and along the sides including front tires at ground level.
The driver’s seat shall be high-back type with a minimum seat back adjustment of 15 degrees and a head restraint. When at fullest extension from the steering wheel, minimum distance between steering wheel and backrest shall be 11 inches. The seat shall have vertical and fore-and-aft adjustment of not less than 4 inches.
Interior lamps shall adequately illuminate the aisle and stepwell. Interior lights shall operate with the ignition key in any position. The stepwell light shall be illuminated by a service door-operated switch (illuminates only when ignition/headlights/clearance lights are on and the service door is opened). Buses shall be equipped with amber signal lamps mounted as high and wide apart as practicable. Turn signal lamps shall flash at 60 to 120 times per minute. Buses shall have four combination red stop and tail lamps. Backup lamps: minimum 4 inches diameter, maximum 7 inches. If a strobe is installed, it must comply with state and federal standards with clear white lens only and maximum height above roof less than 8 inches.
The windshield shall be AS-1 safety glass. A two-speed or variable speed wiping system with intermittent features shall be provided. Electric, air, or vacuum-powered windshield washers are required.
Type A: each passenger-side window shall have an unobstructed opening of at least 9 inches in height and 22 inches in width. Type C and D: at least 12 inches in height and 22 inches in width.
Know the location of: fire extinguisher (minimum 5 B:C rating), first aid kit, reflective warning triangles, seat belt cutter and window punch (if equipped), bodily fluid cleanup kit, and wheelchair securement devices. Emergency exits must be clearly marked and unobstructed at all times.