fbpx

9.1 Americans With Disabilities Act (ADA) Compliance

Overview

On July 26, 1990, the Americans with Disabilities Act went into effect. Both public and private organizations must comply with ADA guidelines. The FMCSA oversees DOT’s ADA regulations which outline accessibility and timely OTRB service for passengers with disabilities. The ADA’s goal is to prevent discrimination and ensure equal opportunity, allowing persons with disabilities to participate fully and live independently.

Accessible Over-the-Road Bus (OTRB)

An accessible OTRB has: a lift, ramp, or other device for passengers who cannot climb steps; two specific locations and equipment for securing wheelchairs; signage in large print, braille, and alternative electronic format; marked forward-facing seating reserved for people with disabilities; slip-resistant surfaces on ramps, doorways, and steps; illuminated doorways and stepwells; adequate room for wheelchair maneuvering; vertical rails and handrails; and communication tools (button or pull cord) near wheelchair securement locations. At a minimum, lifts must accommodate wheelchairs measuring 30 inches by 48 inches and be designed to load 600 lbs. or more.

Equivalent Service

If a small operator cannot provide an accessible OTRB, they must provide equivalent service with a different accessible vehicle that travels to the same location, at the same rate, and within the same time frame. You cannot charge additional fees to persons with disabilities for equivalent service. A small OTRB operator is defined as having gross annual transportation revenue of less than $9.9 million.

ADA Regulations — No Discrimination

OTRB operators cannot: deny transportation based on a disability (they can deny service for violent, disruptive, or illegal behavior, but not because a disability causes involuntary behavior that may offend or annoy others); request non-employees to assist passengers with disabilities unless the passenger requests it; require a passenger to reschedule or travel at a different time; or fail to provide equivalent reservation services.

Wheelchair Lift and Loading Process

Tell the passenger what you are going to do before you do it. Open and secure the lift door. Lower the platform until it rests on the ground. Back the passenger onto the lift — always face the passenger away from the vehicle. Lock wheelchair brakes. Fasten the wheelchair seat belt. If powered, turn off wheelchair power. Have the passenger hold handrails if able. Keep arms and legs within the lift area. Stand at the front corner with one hand on the wheelchair. When the platform reaches floor level, release brakes, push the wheelchair in, set brakes, and fold the lift.

Wheelchair Securement System

A seven-point system is used: four points to secure the wheelchair and three points to secure the passenger. The wheelchair must be forward-facing. The shoulder belt MUST be attached to the vehicle. The lap belt can be attached to the wheelchair 4-point system or to the vehicle. All new buses since January 1994 have forward-facing systems. Wheelchair securement positions are inherently safer — the human body is better capable of surviving a frontal crash when facing forward. Sled tests show side-facing wheelchairs are unstable and often collapse.

Anchoring and Securing

Use only a 4-point tie-down with separate occupant restraint. Don’t interchange manufacturers’ systems. Never place a wheelchair in front of an emergency exit door. Center the wheelchair with anchorages. Set brakes on both sides and turn off power. Attach wall-side straps first, then aisle-side. If you can’t get the wheelchair attached properly, call dispatch for guidance.

Securing the Passenger (3-Point System)

Position the lap belt over the pelvic bones, not the abdomen, inside the armrests. Adjust snugly. Position the shoulder belt so it does not cross the face or neck — never under the arm where it would cross the rib cage. Never twist the belts; they should lie flat. If the lap belt won’t tighten properly, call dispatch — they may arrange equivalent service until repair is made.

Service Animals

The ADA defines service animals as dogs individually trained to do work or perform tasks for people with disabilities. Service animals are not pets — they are working animals. Examples: guiding the blind, alerting the deaf, pulling a wheelchair, protecting during seizures, reminding to take medications, assisting during PTSD anxiety attacks (Psychiatric Service Dog). Emotional support dogs whose sole purpose is to provide comfort do not qualify as service dogs under ADA guidelines. Special training and certification are not required. Service animals in training are not yet classified as service dogs and can be excluded. Service dogs do not have to wear identifying vests under ADA (though state laws may differ). Handlers must maintain control of their animals.