This lesson covers: proper methods for handling and securing passenger baggage and containers; procedures for identifying and inspecting baggage and containers for prohibited items such as hazardous materials; and proper handling and securement of devices associated with ADA compliance, including oxygen, wheeled mobility devices, and other associated apparatuses.
Do not allow riders to leave carry-on baggage in a doorway or aisle. There should be nothing in the aisle that might trip other riders. Secure baggage and freight in ways that: allow the driver to move freely; allow riders to exit by any window or door in an emergency; and protect riders from injury if carry-on baggage falls or shifts.
Watch for cargo or baggage containing hazardous materials. Most hazardous materials cannot be carried on a bus. The Federal Hazardous Materials Table identifies materials that pose a risk to health, safety, and property during transportation. There are nine different four-inch, diamond-shaped hazard labels. Do not transport any hazardous material unless you are sure the rules allow it. Do not allow riders to carry on common hazards such as car batteries or gasoline.
Buses must never carry: Division 2.3 poison gas, liquid Class 6 poison, or tear gas/irritating material; more than 100 pounds of solid Class 6 poisons; explosives in the space occupied by people (except small-arms ammunition); labeled radioactive materials in the space occupied by people; more than 500 pounds total of allowed hazardous materials; and no more than 100 pounds of any one class. Buses may carry small-arms ammunition labeled ORM-D, emergency hospital supplies, and drugs.
Oxygen may be transported on buses only when medically necessary. The bus should display signs: NO SMOKING, NO OPEN FLAMES, CAUTION – OXYGEN ON BOARD. Oxygen cylinders should be securely mounted to a wheelchair bracket, bus sidewall, or bus floor. Oxygen transport bags or pouches should not be used on buses. Liquid oxygen containers must be secured in an upright position to prevent leakage and stored in a well-ventilated area. Do not allow open flames, sparks, or heat sources within 5 feet of an oxygen delivery system. Do not apply oil or lubricants to any oxygen device.
General guidelines when passengers are on the lift platform: the passenger always faces away from the bus, wheelchair brakes are locked, roll stops must be in the completely up position. To unload a motorized wheelchair, the passenger should NOT drive onto the lift unless cleared to do so — disengage the motor and push the chair manually.
Use only a 4-point tie-down system with a separate restraint for the occupant. The wheelchair must be forward-facing. The shoulder belt MUST be attached to the vehicle. The lap belt can be attached to the wheelchair 4-point system or to the vehicle. Don’t interchange manufacturer systems. Never place a wheelchair in front of an emergency exit door.
Securement Checklist: Wheelchair is forward-facing and centered on anchorage; brakes set and power off; anchored at 4 points per manufacturer’s instructions; straps at as close to 45-degree angle as possible (no less than 30, no more than 60 degrees); not attached to wheels or detachable parts; no bending around objects; away from sharp edges; no crisscrossing or twisting; no forward or reverse movement.