This section guides you in recognizing potential dangers and appropriate safety procedures at railroad-highway grade crossings. It covers federal/state regulations, crossing environments, obstructed view conditions, clearance around tracks, rail signs and signals, and Emergency Notification Systems (ENS).
These crossings are always dangerous. Every crossing must be approached with the expectation that a train is coming. It is extremely difficult to judge the distance or speed of an approaching train.
Passive Crossings: No traffic control device is installed. The decision to stop or proceed rests entirely in your hands. You must recognize the crossing, search for any train, and decide if there is sufficient clear space to cross safely.
Active Crossings: Traffic control devices are installed — flashing red lights (with or without bells) and flashing red lights with bells and gates.
Advance Warning Signs: Round, black-on-yellow warning sign placed ahead of crossings. All passenger and hazmat-carrying vehicles are required to stop.
Pavement Markings: An “X” with the letters “RR” and no-passing markings. There may be a white stop line — the front of the bus must remain behind this line.
Crossbuck Signs: Mark the grade crossing. Require you to yield right-of-way to the train. Vehicles required to stop must stop no closer than 15 feet or more than 50 feet from the nearest rail. A sign below the crossbuck indicates the number of tracks.
Flashing Red Lights: When they begin to flash, stop! You must yield right-of-way. If there is more than one track, make sure ALL tracks are clear.
Gates: Stop when lights begin to flash and before the gate lowers. Remain stopped until gates go up and lights stop flashing.
Never race a train to a crossing. Reduce speed according to your ability to see approaching trains. Don’t expect to hear a train — noise inside your vehicle may mask the horn. Don’t rely solely on signals. Double tracks require a double check — a train on one track may hide one on another. Yard areas and crossings in cities and towns are just as dangerous as rural crossings.
When stopping: check for traffic behind you, use a pullout lane if available, and turn on four-way emergency flashers. Do not shift gears while crossing railroad tracks. Never stop on the tracks. Ensure sufficient space on the other side to completely clear.
Get out of the vehicle and away from the tracks. Check signposts or signal housing for emergency notification information. Call 911 or another emergency number. Give the location using all identifiable landmarks, especially the DOT number if posted.
The FRA requires each railroad to have ENS signs at each crossing. The blue ENS sign includes the railroad’s emergency contact number (800 number) and the USDOT National Crossing Inventory Number — a unique number that identifies the exact crossing location.
Stop at drawbridges that do not have a signal light, traffic control, or attendant. Stop at least 50 feet before the draw and look to make sure it is completely closed. You do not need to stop (but must slow and check) when there is a green traffic light or a bridge attendant/traffic officer controlling traffic.